Stiga PlayTheBest T8525 Manual Del Propietário página 3

ATTACHING LEGS TO TABLE TOPS
CAUTION
1
2. Leave top halves #1 in shipping carton as shown
above or lay them on a carpeted floor (to protect
them from damage and scratches ).
3. Attach leg assembly #10 to brackets #6 located on
the bottom of the first top half #1. (See above).
Use bolts #29, spacers #20 and locknuts #28.
(See Detail A and Detail B).
NOTE: Be sure brace on leg assembly #10 is against
table (See above). Tighten these locknuts snug but
DO NOT OVERTIGHTEN THEM.
JOINT MUST MOVE!
4. Screw Nuts #33 onto leg levelers # 9 and Put
Levelers #9 on bottom end of leg assembly #10.
(See Detail A)
AT LEAST TWO ADULTS ARE NEEDED TO
COMPLETE THE FOLLOWING STEPS!
31
28
5. Attach upright assembly #11 to remaining brackets
#6 on the bottom of the first top half #1. (See above).
Use bolts #26, spacers #20, and locknuts #28.
(See Detail A and C). Tighten locknuts snug but DO
NOT OVERTIGHTEN them. JOINT MUST MOVE!
6. If not already installed, slide Right
#31 Rail caps onto the end of the rails as shown.
7. With a helper , set the first top half #1 on its side
against a wall. ( Be sure to put a piece of cardboard,
cloth, or carpeting on the floor first to protect the
top's edges). Turn the second top half #1 over and
repeat steps 3-6 to assemble it.
3
29
30
33
9
# 30 and Left
Rail not
shown for
clarity.
29