General Safety Rules - Wagan Tech Dynamite Power Manual De Usuario

Dynamite Power Air Compressor
Thank you for purchasing the Dynamite Power Air Compressor by Wagan Tech.
With normal care and proper treatment, it will provide years of reliable service.
Please read and understand all operating instructions carefully before use.

GENERAL SAFETY RULES

• The unit has a built-in automatic reset thermal overload protector which will
shut off the motor if it becomes overheated. The protector will automatically
reset when the motor cools down.
• After using the unit, allow sufficient cooling time before storing
• All parts are lifetime lubricated, and no oiling is required
• To prevent a drop in your car's battery voltage, please have the engine
running when using the air compressor
• Make sure that the unit's power switch is in the OFF position when not in
use.
OPERATION
Cars, Trucks, RV's, and Motorcycles:
Note: before inflating your tires, make sure you to check your vehicle's manu-
facturer recommended tire pressure, which should be located on your vehicle's
driver side door.
1. Start your vehicle's engine, then plug the compressor's power cord into the
12 volt cigarette lighter socket of your vehicle.
2. Screw the air hose's brass valve tip directly onto the tire's air valve.
3. Turn the compressor ON—begin to inflate tire.
4. When the pressure gauge indicates the desired pressure switch the unit OFF
and remove the air hose from the valve (normal tire pressure is 28–35 PSI).
5. Before storing the unit, allow sufficient time for it to cool.
1
by Wagan Tech
™
www.wagan.com
®