Assembly And Adjustment - BLACK&DECKER BDCS40G Manual De Instrucciones

• To install a bit, insert it into the cavity in the hex
INSERTING AND REMOVING BITS (FIGURE C)
spindle as shown in figure C.
• To remove the bit pull it straight out.
• For bit tips, use a bit tip extender as shown.
NOTE: Only hex end bits will fit in spindle.
• Do not use screwdriver as a pry bar in any position.
WARNING:
• To avoid screwdriver being turned on
accidentally, do not carry in your pocket.
Your screwdriver uses gyroscopic technology to sense your hand motion. To operate,
press in the motion control activator on the back of the tool with your palm and turn
your hand in the direction that you want the screwdriver to operate.
SETTING INITIAL STARTING POINT
• Grasp the screwdriver as shown in figure D.
• Press and hold in the motion control activator on the back
of the tool with the palm of your hand.
• When the LED illuminates the tool is ready for use.
• To reset initial starting point first release the motion control
activator. Move tool to new position, then press and hold in
the motion control activator on the back of the tool with the
palm of your hand.
OPERATING IN FORWARD DIRECTION
• Grasp the screwdriver as shown in figure E.
• Engage head of fastener with screwdriver accessory
on work piece. Follow instructions for setting initial
starting point.
• Rotate your hand to the right and the screwdriver will
activate in the forward direction.
OPERATING IN REVERSE DIRECTION
• Grasp the screwdriver as shown in figure E.
• Engage head of fastener with screwdriver accessory
on work piece. Follow instructions for setting initial
starting point.
• Rotate your hand to the left and the screwdriver will
activate in the reverse direction.
To turn the tool off, release the motion control activator.
NOTE: When the tool is not in use or during transit please be sure to remove any
accessory from the tool.
• To maintain battery life in the case of accidental actuation, this unit will shut itself off
45 SECOND AUTOMATIC SHUT OFF
after 45 seconds of continuous operation. The LED will flash rapidly for 5 seconds
before the unit turns off.

ASSEMBLY AND ADJUSTMENT

OPERATING INSTRUCTIONS
C
D
E
E1
7