Surface Mount Installation
1
DETERMINING THE MOUNTING LOCATION
NOTE: Before installing, make sure all parts are
present. Compare parts with the Hardware Included
list. If any part is missing or damaged, do not attempt
to install the product.
□ Determine the desired mounting location, and
mark the wall where the unit will be installed.
3
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws with washers (not included) through the pre-drilled cabinet holes and into the
stud locations.
□ For drywall installation, drill holes at the appropriate locations and insert toggle bolts with washers
(not included) through the pre-drilled cabinet holes and into the drywall.
□ For concrete wall installation, drill 1/4 in. holes
at the appropriate locations and insert #12 wall
anchors (not included) into the holes. Then insert
#12 x 3 in. screws (not included) through the
pre-drilled cabinet holes and into the anchors.
4
INSTALLING THE SHELVES
□ Insert the left shelf clips (AA) into the holes on the left side of the cabinet.
Repeat on the right side (BB).
□ Rest the shelves (CC) on the shelf clips (AA and BB).
Troubleshooting
Problem
The doors do not align or
the space is too big or too
tight between the doors.
*Some models do not have adjustable hinges.
Safety Information
Please read and understand this entire manual before attempting to assemble, operate, or install the product.
Care and Cleaning
□ Use a water-dampened cloth to clean the bath storage cabinet frame.
□ For the mirrors, use ammonia-free cleaning products.
Possible Cause
The hinges are misaligned.
2
PRE-DRILLING THE BACK OF THE CABINET
□ Drill 1/8 in. diameter holes through the back
panel of the cabinet on all four corners.
□ Make sure to drill holes through hanging support boards
Solution
Hold the door while
loosening screws. Align
the doors properly, and
re-tighten the screws.
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
BB
AA
CC
Up — Down
In — Out
Left— Right