Setup Instructions - Polygroup SUMMER WAVES Manual Del Usuario

1. THE PRODUCT SUITS FOR 10'-20' FRAME POOLS.
2. CHECK TO MAKE SURE THE VERTICAL BEAMS OF YOUR POOL BELONG TO ONE OF THE
BELOW SHAPES AND SIZES:
Shape
Size
Position of Fitting Block
3. Align the Fitting Block with the correct position number (see above) and slot
the fitting blocks into the Frame Clamps. You should hear a click when
secured.
NOTE: Before moving to the next step, make sure the Fitting Block is in the
correct position. With the frame clamp, if not, refit the Fitting Block by:
a. Pressing both the snaps towards the center, and
b. Pushing the Fitting Block out of the Frame Clamp.
4
3
2
1
5. Snap the Beam Connectors onto the Vertical Beams.
Beam Connector 3
4

SETUP INSTRUCTIONS

A B
66 mm Width 60 mm Width
D-shaped D-shaped
1 2
"Click"
Fitting Block
C D
55 X 35 mm Oval 1.5" Round
3 3
4. Insert and secure the Vertical Beams into the Frame Clamps.
6. Install the assembled Vertical Beams onto the pool vertical beams.
NOTE: Open or close the Clamps CAREFULLY to avoid breaking them.
E
1.25" Round
4
Vertical Beam 4