Maintenance; Replacing The Battery; Specifi Cations - Mitsubishi Electric EY-3DGS-80U Manual De Usuario

Maintenance

• When the 3D glasses become dirty, wipe them with a soft and dry cloth.
If you wipe them with a dirt cloth, the lens (liquid crystal shutter) or the infra-
red reception section may be damaged.
• Do not use benzine or thinner to clean the 3D glasses. It may cause
deformation of the surface.
• Do not soak the 3D glasses in water.
• Do not wipe the lens with alcohol or other chemicals. The lens may be
discolored.
• Avoid keeping the 3D glasses in a place of high temperature or high humidity.

Replacing the battery

When the indicator goes off immediately after the 3D glasses are turned on, or
the indicator doesn't light up even after the power switch of the 3D glasses is
set to ON, replace the battery with a new one.
See page 8 for the replacement procedure, and remove the old battery before
installing a new battery.
Specifi cations
The specifi cations and outside appearance are subject to change without prior
notice.
Model
Lens system
Power supply
Dimensions (W x H x D)
Weight
Materials
Operating temperatures
EN-12
EY-3DGS-80U
Liquid crystal shutter
DC 3 V, coin type lithium battery (CR2032) 1
170.5 x 41 x 187 mm
54 g (excluding the battery)
Body: ABS resin
Temple: PC resin
Lens: Liquid crystal glass
+41°F (+5°C) to +95°F (+35°C)