Glacier bay 35644BNHD Guía De Uso Y Cuidado página 6

Installation (continued)
3
Fastening the end caps
□ Slide the end cap (E) onto the 7/8 in. diameter tube
assemblies (C).
□ Snap the the end cap (E) to the mounting bracket (B) for the
7/8 in. diameter tube assemblies (C).
□ Repeat this step for the 1 in. diameter tubes (D).
4
Connecting the tubes
NOTE: The flat side of the FRONT
should be facing down.
NOTE: The flat side of the REAR
should be facing down.
□ Insert one plastic ring (AA) into the end of the 1 in. diameter
tubes (D).
□ Insert the end of the 7/8 in. diameter tube assemblies (C)
into the end of the 1 in. diameter tubes (D).
1 in. diameter tubes (D)
1 in. diameter tubes (D)
make sure end cap dimples
line up with the notches in the
mounting bracket
C
6
dimples on end cap (E)
B
C
dimples on end cap (E)
C
AA
D
D
E