Child-Proof Lock - Saivod LST-1289 Manual Del Usuario

opening the door.
Door lock
The loading door can not be opened yet due
to safety reasons while the "Ready" lamp is
flashing. The loading door can be opened once
the "Ready" lamp starts lighting up continuously.

Child-proof lock

You can protect the appliance from being
tampered by children by means of the child-
proof lock. In this case, no change can be made
in the running program.
C
Your machine can be turned on and off with
On/Off button while the child-proof lock is
activated. In this case, your machine will
resume its program with child-proof lock
activated.
The machine is switched to child-lock by
pressing the 1st and 2nd auxiliary functions for 3
sec. "C on" (Child lock is activated) label appears
on the screen. The same symbol will also be
displayed whenever any button is pressed while
the machine is child-locked.
Child-proof lock lamp on the program follow-up
indicator will light up when the child-proof lock is
activated.
To deactivate the child-proof lock, press the 1st
and 2nd auxiliary function buttons for 3 sec. "C
OFF" (Child-proof lock is deactivated) symbol
appears on the screen. Child-proof lock lamp on
the program follow-up indicator will go off when
the child-proof lock is deactivated.
Ending the program through
canceling
"Start/Pause/Cancel" button is pressed for
3 seconds to cancel the program. "Ready"
warning lamp flashes during canceling and "End"
will appear on the display.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
If more than a normal amount of water
C
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its original
location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where they
are connected to the tap. These filters prevent
the foreign substances and dirt in the water to
enter into the machine. Filters should be cleaned
as they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses to
clean the surfaces of the filters on the water
intake valves with an appropriate brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
• Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
Draining any remaining water and
cleaning the pump filter
Your product is equipped with a filter system
which ensures a cleaner water discharge that
9 - EN