Hisense DH-35K1SCLE Guía De Instrucciones página 6

If the bucket is not in position remove the bucket and
■
.
reinstall it Make sure the bucket fits all the way into the
dehumidifier and the light is off or dehumidifier
run.
Fan Speed
1.Press FAN to select fan speed.
2.Choose Low, High or Auto.
LOW- Will reach the desired humidity setting with lower
■
sound level .
■ HIGH-Will reach the desired humidity setting faster.
AUTO-Will provide the maximum humidity control by
■
automatically adjusting the fan speed.
NOTE:
Once the humidity set point is reached,the
dehumidifier will stop running continuously,and the fan will be
off periodically.The fan may periodically turn on, to read the
humidity level, without the compressor running.
Mode
1.Press MODE to select the desired humidity setting.
2.Choose Auto Dry, Continuous or Manual Set.
AUTO DRY: The dehumidifier will operate in Dry mode only.
■
Auto Fan Speed is set automatically. The Desired Humidity
is set to 50% automatically.
CONTINUOUS: The dehumidifier will operated
■
continuously.
The Fan Speed can be adjusted. The Desired Humidity can
not be adjusted. The LED display will show the room humidity
level.
■ MANUAL SET:The dehumidifier will operate at the selected
fan speed and desired humidity.If the humidity levels of the
room is higher than the desired humidity setting, the
compressor will turn on. If the humidity level of the room is
lower than the desired humidity setting, the compressor will
turn off,as well as the fan.
NOTE:
The de-icing function will turn off the compressor if a low
temperature condition occurs. Pressing the MODE button or
the plus or minus button will not increase or decrease the
amount of moisture removed. When the de-icing function
senses then correct operating temperature, the
compressor will cycle back on.Some freezing is normal will
dehumidifiers are used at low temperatures.
,
,
will not
Power
Press POWER to turn on or turn off the dehumitifier.
Humidity Level
1. Press the Plus or Minus button to activate the humidity setting
program. Digits in the digital display will flash.
2.
Press the Plus or Minus button again to set your desired
humidity.
3. Digital display will stop flashing five seconds after setting.
Actual room humidity will be displayed.
NOTE:
Humidity can only be adjusted manually in Manual Set mode.
In Continuous and Auto Dry mode, humidity level is set automatically.
Digital Display
Display shows relative humidity or time (depending on setting).
1.When the dehumidifier operates in Manual Set modes,the
display shows the relative humidity of the room.
2.When the timer is selected, the display shows the time when
the dehumidifier will turn on or turn off, depending on the setting.
3.For heat function model, when the dehumidier operates
in heat mode, the display shows the room temperature.
NOTE:
The humidity displayed is only for reference. For accurate humidity,
please check a hygrometer.
Timer
To set Timer for a 30-minute to 24-hour delay before the
dehumidifier is turned off (the dehumidifier must be On):
1. Press TIMER. Timer indicator light will come on, the Display
will flash. The display will show remaining time before the
dehumidifier will turn off.
6
.
.