Step 3: Assign An Ip Address - Lexmark MarkNet N2000 Serie Referencia Rápida

MarkNet N2004fl
models
MarkNet N2004fl-SC
Step 3: Assign an
IP address
NETWORK MENU
Menu
Select
Use these print servers to attach printers to a 10Base FL fiber optic
network or an Ethernet 10BaseTX network.
MarkNet N2004fl-ST
You must assign an IP address, netmask, and gateway to each print
server you install in order for other network devices to find the printer
on the network.
If your network is using DHCP, address values are automatically
assigned. To verify the address assignment, print a network setup
page and make sure the IP address, netmask, and gateway appear
as non zero. Go to "Step 4: Print a network setup page" on page 5.
If your network is not using DHCP, then you must manually assign an
IP address. One of the easiest ways is to use the printer operator
panel.
To set the printer IP address, netmask, and gateway:
1
Press until you see Network Menu, and then press
Menu
.
Select
2
Press until you see Network Option 1 (or 2), and then
Menu
press .
Select
3
Press until you see Network 1 Setup (or 2), and then
Menu
press .
Select
4
Press until you see TCP/IP, and then press
Menu
5
Press until you see Set IP Address (or Set IP Netmask or
Menu
Set IP Gateway), and then press
4
MarkNet N2004fl-MTRJ
Select
t.
Selec
.