Publicidad
Idiomas disponibles
Idiomas disponibles
GB
The following additional items are required for the installation:
Alcohol or petroleum ether for degreasing
Cloth
Drill with 2.5 mm drill bit
Screw driver
General information and tips
Reimo mosquito nets are made of high-quality, extremely close-mes-
hed and flexible material.
To prevent damage, please ensure that the Velcro strips face one
another when folding the net.
Attach the fleece band at a temperature of more than 20° Celsius;
otherwise the glue will not adhere properly to the surface.
Install the mosquito net for sliding doors when the door is closed.
This is the only way the space requirement for the arm of the sliding
door rail can be taken into account.
Preparation of the vehicle:
To achieve optimal adherence of the fleece band, clean and degrease
the surface thoroughly with alcohol or petroleum ether. (Allow the air
to exhaust from around the product!)
Preparation of the fleece band:
Use the mosquito net as a template.
To glue on the fleece band in the proper position, it is recommended
to "Velcro on" the fleece band onto the mosquito net first, starting at
the bottom of the left or right side (the fleece band is U-shaped).
Gluing on the fleece band:
Hold the mosquito net including the fleece band into the door ope-
ning with the sliding door closed.
Mark several spots where the fleece band will be glued on later.
Start gluing on the fleece band (the mosquito net is stapled onto the
fleece band) at the most suitable place, depending on the vehicle
type. Carve the protective foil in several spots.
Gradually remove the protective foil, while gluing on the fleece band.
Keep checking that the course of the mosquito net in relation to the
door / window opening is correct. Carefully remove the mosquito net
from the glued on fleece band. Carefully rub on the glued on fleece
band. A small piece of wood or similar material can be used as tool
in narrow spaces.
Allow the glue of the fleece band to dry for some time (ideally 24
hours).
Reattach the mosquito net and mark the positions of the snap fa-
stener in the centre of the sides, using a suitable pen.
Remove the mosquito net again. Attach the under part of the snap
fastener through the fleece band using tapping screws. Use a 2.5
mm drill bit to screw on the screws to the sheet metal of the vehicle.
Mosquito stop installation instructions
Mosquito net for installation into the opening of the sliding door
Install with the sliding door closed!
Tolerance compensation
Because minimal dimension differences can occur in vehicles and
equipment, tolerance compensation as described below may be ne-
cessary for optimal adjustment.
When gluing on the fleece band, a wave may form on the mosquito
net. Simply glue the self-adhesive fleece band together in this area,
creating a small fold.
Pre-assembled
Important note:
Pursuant to the road traffic regulations, operating a vehicle
with installed mosquito nets on the driver's and front-seat pas-
senger side windows is not permissible in the region of the Fe-
deral Republic of Germany. This applies to all roads dedicated
to public traffic.
When making trips to abroad, please inquire about the regu-
lations pertaining to the respective country.
Our mosquito nets are manufactured diligently, using high-quality
materials. If you have any concerns or complaints, please contact us
in writing at: Reimo Reisemobil GmbH, Department for product care,
Boschring 10, 63329 Egelsbach or at: www.reimo.com
Caution:
Publicidad
