Nostalgia Electrics CCP810 Instrucciones Y Recetas página 9

SCREWS(8mm)
Assembly of Base Support
1. Push Handle (E) attaches onto the Concession Stand (C) using the four supplied #1 Screws.
2. Insert Cross Bar (J) into the square inserts on the inside of Base Support (I) and
secure from below with two #2 Bolts and two #5 Flat Washers. Insert the Leg
Assembly (K) into the square inserts between the ends of the Base Support (I)
and fasten from inside with two #3 Bolts, two #5 Flat Washers, and two #6 Nut
Caps. Also secure from above with two #2 Bolts and two #5 Flat Washers.
3. Assemble Base Support (I) into the bottom of the Concession Stand
(C) and secure with four #2 Bolts and four #5 Flat Washers.
7
第4页 第4页