Attaching The Auxiliary Handle; Height Adjustment - Black and Decker NST2036 Manual De Instrucciones

90528621 36 volt trimmer 11/5/07

ATTACHING THE AUXILIARY HANDLE

• Separate the handle pieces as shown in
figure E.
• Attach the handle to the metal shaft of
the trimmer with the curved edge facing
forward. Push down on the handle so
that it engages with the slot in the shaft.
• Attach the two handle pieces using four
hex head screws as shown in figures F
and G.
• Fully tighten screws with hex wrench.
F
7:46 AM Page 9
AUXILIARY HANDLE ADJUSTMENT
• For maximum comfort and control, adjust the auxiliary handle to
E

HEIGHT ADJUSTMENT

• The overall height of the trimmer can be adjusted by loosening the
• If the lever becomes loose it can be tightened using the hex wrench.
G
9
suit your height. Shorter users adjust handle to a lower position
(away from you) and taller users, adjust handle to an upper
position (towards you). The handle should be adjusted so that
your front arm is straight when the trimmer is in the working
position.
collar lock lever as shown in figure H. The tubes can then be
shortened or lengthened (figure I). When the desired height is
achieved return the collar to the lock position.
H
I