Configuration Of The Sce - Parker SensoControl SCE-020 Instrucciones Para El Manejo

4.3.

Configuration of the SCE 020-02

All basic parameters ( End, ...., in 0, inFS ) are to be either set or
changed similar to the programming of the SCE-020-0 (see also 4.1
and 4.2).
In this version a serial interface RS232 and a potential-free relay
contact (220VAC/5A) are available for which it is possible to set
corresponding limit values. The data output format can be effected
with a choice between a decimal comma or decimal point (see
Fig. 5).
In this version the configuration menu is extended accordingly in
order to change and set the required parameters:
Function
Baud rate
Scanning rate
Limit value on
Limit value off
4.3.1 Data output format with a decimal point –
(M2.1)
The corresponding configuration is carried out together with Section
4.2.1. M2.1 is selected with the + / - key and the parameter selection
is activated by pressing the SET key. The position of the decimal
point is set with the + / - keys. The data format consists of the
number of decimal places and a decimal point. Pressing the SET
key ends the setting (see also Section 4.2.1.)
Menu
bAud
rAte
Li 1
Li 0
- 10 -