Soundoff Signal nROADS ENRBCSHM Serie Instrucciones De Montaje página 2

Screw together until snug
and "REAR" is facing the rear
of the vehicle
PIPE MOUNT
2.
1" NPT Pipe
"REAR" needs to face the
rear of the vehicle
Mounting Gasket
Mounting
Holes x3
FLAT MOUNT
Mounting
5/8"-1" Center Hole
Surface
nROADS Mounting Instructions
Flat Mount:
1. Using the supplied gasket, mark the center hole
and three mounting holes on the surface the
beacon will be mounted to.
2. Drill your holes.
a. The center hole should be large enough for the
wires to pass, between 5/8" and 1".
b. The 3 mounting holes should be drilled for
clearance for #10 bolts (1/4").
3. Using #10-32 bolts of suitable length (installer
supplied) secure the beacon to the mounting
surface making sure the gasket is between
the beacon and the mounting surface. (SoundOff
Signal recommends using flat washers and lock
washers to secure the beacon to your mounting
surface).
Pipe Mount:
1. The beacon is pre-threaded to fit a 1" NPT pipe.
2. Insert wires into the pipe making connections you
wish to use.
3. Screw the beacon on the pipe until snug.
4. The aluminum base is marked "REAR". Rotate the
beacon until the "REAR" is facing the back of the
vehicle. This is important for specific light
modes.
nROADS Beacon_9-32Vdc 0318