Installation - Glacier bay HD67685W-5004 Guía De Uso Y Mantenimiento

Installation

1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Remove the preassembled lock nut (D) and
washer (C) from the new faucet (A).
□
WITH NO DECK PLATE:
body (A)-including inlet tubes, hose (1) and sensor
cable (2)-through the hole in the sink.
□
WITH DECK PLATE:
gasket (G) and deck plate (F) with the mounting
holes in the sink. Install the faucet body (A)-
including inlet tubes, hose (1) and sensor cable
(2)-through the middle hole in the deck plate (F).
NOTE: Silicone sealant is required under the gasket (G).
Install the faucet
A
2
1
Align the holes in the
A
F
G
2
1
2
Securing the faucet assembly
□
Install the washer (C) onto the threaded bolt.
□
Thread the lock nut (D) onto the bolt using the
wrench (E) provided to tighten rmly.
C
2
4
C
1
D
E
D
E