Efergy SHOWERTIME Manual De Instrucciones

SAVE ENERGY
The efergy showertime works by gauging the average output of water
from your shower and programming it to a timer with an audio alert.
Each time you have a shower simply press the tick button and the
showertime will display your usage and alert you when your personal
target is reached.
SETTING THE TIME
To activate the display pull the battery slip
• Press and hold the tick button for 3 seconds to set the time on your
24 hour display
• Use the up and down buttons to set the hours and minutes, pressing
the tick buttons to exit the set up
CALIBRATING THE SHOWERTIME
• Press and hold the up button for 3 seconds to start calibration
• Open the calibration bag and place around the showerhead
• Press the tick button at the same time as turning on the water, and
a countdown of ten seconds will start on the display. Turn off the water
when the ten seconds are finished.
• Using the up and down buttons set the flow rate indicated on the
bag, and press the tick button to save the value.
SELECTING VOLUME UNIT
Pressing the up and down buttons at any time will change the volume
unit between litres (L) to Gallons (G) to US Gallons (US G)
VOLUME MODE
Setting the Volume Alarm
• To set the volume mode and alarm, press the down button for 3
seconds and press the tick button to enter the volume mode
• Use the up and down buttons to select the volume and press the tick
button to exit
Using the Volume Mode
Once the tick button has been pressed the volume will start counting
up and the time required for the volume to be filled will start counting
down until the alarm is reached.
Without calibrating the showertime, you cannot use the volume mode.
TIMER MODE
Setting the Timer Alarm
• To set the timer mode and alarm, press the down button for 3
seconds and then press the up button to enter the timer mode.
• Use the up button for seconds and the down button for minutes to
select the maximum time to be spent in the shower.
• Press the tick button to exit
Using the Timer Mode
Once the tick button has been pressed the time will start counting
down and the volume will start counting up until the alarm is reached.
Without calibrating the showertime, the timer mode will not be usable.
Note: To reset the unit hold the up and down buttons for 3 seconds
SHOWERTIME
TEMPORIZADOR DE DUCHA Y ALARMA
MANUAL DE INSTRUCCIONES