Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Product Assemblies
SP-PSF-11-SH1-W
SP-PSF-14-SH1-W
Remove false drawer panel from cabinet.
1
Locate the hinges inside the cabinet opening,
1/8" (3mm) back from the cabinet front and
even with the bottom of the opening. Be sure
to note right and left hand hinge. Mark center
of screw holes on cabinet and remove hinge.
Drill pilot hole 1/4" deep. Attach hinges
"finger-tight" with provided screws.
Hold false drawer panel in place over cabinet
2
opening. With pencil inside the cabinet, mark
pilot holes for hinge attachment on the back
of the false drawer panel and mark the top of
the cabinet opening on the back of the false
drawer panel. This mark is necessary for
locating the placement of the tray.
Remove the panel and hinges. Drill pilot
3
holes 1/4" deep, taking caution not to drill
through front of false drawer panel. Attach
the hinges to the back of the false drawer
panel in the center of the slots using the
mounting screws provided. Make sure
screws are shorter than the thickness of the
false drawer panel.
Inspect all parts and read all instructions prior to beginning assembly and installation.
Tools Required
• Phillips Head Screwdriver
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
• Tape Measure or Ruler
• Pencil
Parts Included
Sink Front Tray(s)
2
Top of
Opening
Hinge Installed
(Right Side
Shown)
Bottom of Opening
Sink Front Tray Kit
Installation Instructions
Mounting Screws (10)
3
Install Screws in
Center of Slots
False
Drawer
Panel
Back
of False
Drawer
Panel
Hinge
Publicidad
Manuales relacionados para simplyput SP-PSF-11-SH1-W
Resumen de contenidos para simplyput SP-PSF-11-SH1-W
- Página 1 • Tape Measure or Ruler • Pencil Parts Included Sink Front Tray(s) Mounting Screws (10) Product Assemblies SP-PSF-11-SH1-W SP-PSF-14-SH1-W Remove false drawer panel from cabinet. Locate the hinges inside the cabinet opening, Top of Install Screws in 1/8" (3mm) back from the cabinet front and...
- Página 2 Lay false drawer panel face down, and position tray 1/4" below the pencil mark indicating the top of cabinet opening. Center tray on the panel, and make a mark in the top of the keyhole on each end of the tray. 1/4"...
- Página 3 • Lápiz Lista de partes Tornillos de montaje(s) Bandeja(s) frontal(es) del fregadero (10) Assemblages Ensamblaje de productos SP-PSF-11-SH1-W SP-PSF-14-SH1-W Quite el panel del cajón falso del gabinete. Ubique las bisagras dentro de la apertura Parte Instale los tornillos superior en el centro de del gabinete, a 3,1 mm (1/8") hacia atrás del...
- Página 4 Coloque el panel del cajón falso boca abajo y ubique la bandeja 6,3 mm (1/4") debajo de la marca de lápiz que señala la parte superior de la apertura del gabinete.Centre la bandeja en el panel y realice una marca 1/4"...