Unpacking Instruction; Power Supply - Vonyx CDJ500 Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CAUTION LASER RADIATION!
This device is equipped with two Class 1 laser diodes. To ensure a safe operation do not remove any covers or try
to access the inside of the equipment. The inside of the device does not contain any parts which are subject to
maintenance. Maintenance must only be carried out by qualified staff.
OVERVIEW
1. Eject
Press to load or eject disk.
NOTE: Disc tray will not open unless stop or pause button has been pushed first.
2. CD/USB
To enter into the CD or USB mode by this key conversion.
3. PGM Mode
Program up to 20 tracks in PGM-mode:
•
Press STOP button to stop
•
Press the PGM button to program
•
Press Track/Folder search button to select track followed by PGM button.
•
Repeat as necessary
•
Press Play/Pause button to play or pause.
4. Jog mode
Turned ON in search mode. Turned OFF in pitch bend mode.
5. Scratch mode
Enables dual wheel in scratch mode, press again to turn off.
6. Jog & Shuttle Wheel
Shuttle: Use the dial lo select the scanning direction and speed. The disc is scanned in the forward direction when the
shuttle dial is turned clockwise from the neutral position, in the reverse direction when the shuttle dial is turned counter
clockwise. The scanning speeds up when the shuttle dial is turned faster.
Jog: In pause mode, if you turn the jog, the point at which the sound is being produced moves by a number of frames
corresponding lo the number of clicks. Clockwise moves the point forward; counter clockwise moves the point
backward. In play mode, the jog increases or decreases the speed of the song. (Clockwise: increase, counter
clockwise: decrease).
7. Cue
Pressing the CUE button during play provides a return to the position al which play was started.
8. Play / Pause
Each lime you press the play/pause button, the operation changes from play to pause or from pause to play.
9. Track / Folder Search
Allows you to navigate through folders or tracks in either USB or CD mode.
10. Pitch Bend
The pitch will rise or drop when "+ " or "-" pressed and returned to !he original pitch when released.
11. Pitch fader
Use this fader to increase or decrease the speed of the track.
12. Pitch
Press the pitch button to activate the pitch fader. Press the pitch button again to deactivate this mode.
13. Single mode
Press this button to switch between the single and continuous play mode. The selected mode is indicated on the LCD.
In single mode, after each track, the unit stops the reading. In continuous mode, the unit reads all tracks and stops.
14. Time mode
Select time mode for elapsed time, remaining time or total remaining time.
15. Repeat
Use this mode to repeat track or all tracks.
5