Power Dynamics PDX350 Manual De Instrucciones página 5

14. Loop section
A loop repeats the section between the entry point (IN) and the exit point (OUT).
a. To set a loop while the unit is playing, start by pressing the in-button (it will light up)
b. When you reach the desired end loop point press the out-button (it will also light up). The in- and out-buttons will
blink. The loop will continue playing until you press the out-button again allowing the music to continue from that
point on.
c. To re-engage the loop you must press the reloop button.
d. When you have released your loop the in- and out-LED will turn off and the will remain lit to indicate that your loop
is stored in the PDX350 memory.
e. Pressing the in-button again while the unit is playing will erase the previously saved loop while saving your new
loop entry point.
15. CUE
To set a cue-point, press the play / pause button while a file is playing, and use the jog wheel to adjust the file to a
desired point in the track. Pressing the play / pause button will set a cue-point. While the unit is playing and after the
cue point has been programmed, pressing cue will cause the cd-player to enter the pause mode (play/pause button
blinks) at the programmed cue point (the cue led is lit).
16. Play / Pause
Each press of the play / pause button causes the operation to change from play to pause or from pause back to play.
The play/pause button remains lit when in play mode, while it blinks in pause mode.
5