Connect Power - GE UVD6301S Manual Del Propietario E Instrucciones De Instalación

1
MOUNT THE UNIT
Leveling Bracket -
Flange Facing Out
Leveling
Screw
Wood
Screws
Leveling Bracket -
A
Set downdraft into opening. Extend leveling
brackets to floor of cabinet so downdraft sits
straight. (NOTE: Leveling brackets can be
removed and re-attached in other positions.
Bottom flange may have to face inward in tight
cabinet installations.)
B
Secure the downdraft to the countertop as
follows: Hold the downdraft against the back of
countertop cut-out and tighten the 2 mounting
screws (one on each end of unit) on underside
of countertop. Use a shim between screw and
underside of granite countertops.
The ends of the template may be broken or cut
and used as shims if required.
49-2000733 Rev. 1
Installation Instructions
Mounting Screws
Leveling
Screw
Flange Facing In
Bracket
Shim
Countertop
Mounting Screw
Break/Cut the Ends
1
MOUNT THE UNIT (Cont.)
C Screw leveling brackets to bottom of cabinet
using the four wood screws (provided with the
unit) on each side.
D
Tighten leveling screws through leveling
bracket slots to the unit on each side.
E
Place cooktop into the countertop cutout. There
should be 1/8" minimum gap between the front
of the vent trim and the rear of the cooktop.
F Connect duct. Use a roof or wall cap (with
damper) that is intended for use with kitchen
hoods and vent systems.
2

CONNECT POWER

Plug power cord into properly grounded receptacle.
3
INSTALL FILTERS, CHECK
OPERATION
• Press the button on the top cover to raise the
vent.
• Lift the vent straight up and pull forward.
• Slide filter into the retainers and close the vent.
• Turn the knob on the right side of the air vent to
start the blower and adjust the speed.
• To lower the vent, press the button on the top
cover.
NOTE: It is not necessary to turn the fan OFF
before lowering the vent. The fan will automatically
turn off when the vent is lowered. When the fan
is not turned off before lowering the vent, it will
automatically come on at the previously set speed
when the vent is fully raised.
15