Operation And Maintenance; Operation; Maintenance; Technical Features - Astralpool Glassy L Manual De Instalación, Operación Y Mantenimiento

[en]
Fountain units
3) Connect the water supply (②, 1"G).
4) Connect an earth wire to the Glassy anchor (⑧, connect to the anchor). Ensure that the
earth connection complies with applicable regulations in the country of installation.
3

OPERATION AND MAINTENANCE

NOTICE: Protect the water outlet of the equipment from wind and do not operate the
equipment in high winds. If the equipment is installed in an area exposed to winds, the water
outlet may be affected and the water jet may not be regular throughout its trajectory (even
when exposed to only moderate winds).
3.1

OPERATION

NOTICE: Risk of damage to the equipment. Use only an Astralpool DMX driver that is
compatible with the LED light source in the equipment (Astralpool DMX driver references:
66594 and 66595).
The illumination in the equipment is controlled using the DMX protocol.
Models 66560 and 66562: The micro-cuts of the jumping function are controlled by a relay
suitable for the product's technical characteristics.
The equipment can be inclined at angles between 30º and 90º (⑤).
3.2

MAINTENANCE

See the attached manual for maintenance instructions for the stainless steel components.
Check the condition of the internal foam pieces 2 years after installing the equipment. Repeat
this check every six months following this first check.
NOTE: The screws of the lower cover must be tightened to 8N (⑨) to ensure tightness.
4

TECHNICAL FEATURES

Illumination control
voltage
Jumping function
control voltage
Total power
18
66559 66561
Glassy S Glassy L
24 V DC
-
4.5 W 4.5 W
Installation, operation and maintenance manual; Glassy Jet
66560 66562
Glassy S Glassy L
w.J/E w.J/E
24 V DC
28.5 W 28.5 W
67306 67307
Glassy S Glassy L
Without Without
Led Led
-
-
-