Cleaning And Care; Storage - Unold Hair Styler 87515 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 34
9. Shut the appliance.
10. Now work your way down slowly and evenly
to the ends of your hair. Maintain the
appliance firmly closed during this process.
Never work the same part for more than two
seconds to avoid damaging your hair. For
an even and straight look, work your way
straight down keeping the appliance close
to your head. Working your way through
slightly lifting the appliance will give your
hair more volume.
11. Always switch the appliance off using
the EIN/AUS [ON/OFF] switch before
disconnecting the plug from the wall socket.
12. Do not brush or comb your hair, as this
would destroy the waves. Style your hair
with your fingers, if necessary.
13. Please remember that the attachments are
very hot after use. Change the accessories
only after an adequate cool-off time in order
to avoid burns.
hair-crimper:
1. Separate the combed hair into strands no
more than 5 cm wide. If necessary, separate
the strands using hair clips.
2. Switch the appliance on using the „EIN/
AUS" [ON/OFF] switch.
3. Heat the appliance up for a couple of
minutes in order to achieve the best styling
result.

cleanIng anD care

1. Unplug the appliance from the wall socket.
2. Leave the appliance and the attachments to
cool off completely placing them on a heat
resistant surface.
3. Never immerse the appliance or the lead
cable in water or other liquids to clean them.
4. Clean the appliance with a damp cloth.
5. Do not use any scrubbing sponges, abrasive
agents, steel wool, metal objects, disinfec-

Storage

1. Unplug the appliance from the wall socket.
2. Leave the appliance and the attachments to
cool off completely placing them on a heat
resistant surface.
16
4. Open the appliance and place a small
section of hair between the crimping plates
close to the root.
5. Shut the appliance.
6. Maintain the appliance shut for approx.
5-10 seconds. Open the appliance and
check if the result is as desired. If not,
repeat the procedure.
7. Work your way down to the ends of your hair.
8. Repeat steps 3 to 6 to style the remaining
strands.
9. Always switch the appliance off using
the EIN/AUS [ON/OFF] switch before
disconnecting the plug from the wall socket.
10. Do not brush or comb your hair, as this
would destroy the waves. Style your hair
with your fingers, if necessary.
11. Please remember that the attachments are
very hot after use. Change the accessories
only after an adequate cool-off time in order
to avoid burns.
12. TIP: You can also curl your hair with the
straightener! Place the strand between the
plates as usual and straighten your hair.
Shortly before the ends of your hair, turn
the appliance to the inside or the outside
(according to the desired look) to give your
hair a gentle movement to inside or the
outside.
tants or hot cleaning agents, since they can
damage the appliance.
6. Clean the attachments with a damp cloth,
if necessary. Let the attachments dry
completely before using them again or
storing them.
3. To avoid damage to the lead cable, never
wrap it around the appliance.
4. Protect the appliance from dust.

Publicidad

Tabla de contenido
loading

Tabla de contenido