Step 5 - Pairing - Ebode LightSpeaker El Manual Del Propietario

Step 5: Pairing The Transmitter to the speakers
A) Attach the power cord at the "DC IN" connector on
the back of the Transmitter.
B) Turn on the Power Switch.
C) Pairing - This fully automated process will tell the
transmitter where each LightSpeaker
allow you to control each zone separately and make
your LightSpeaker
systems. After you have set the zone switch on each
speaker to the correct zone and you have installed
your light speakers into the correct sockets in the
correct zones (i.e. Zone 1 speakers in Zone 1, Zone 2
LightSpeakers™ in Zone 2) the job is nearly finished all
that remains is allowing the transmitter discover where
each of the installed LightSpeakers
1) To pair your LightSpeakers
transmitter, turn off all of the light switches in the
areas where LightSpeakers
2) Be sure Transmitter is plugged in and the
power button is on.
3) Push the button marked "PAIRING". The PAIRING
LED on the transmitter will begin flashing RED.
14
All manuals and user guides at all-guides.com
®
system secure from other nearby
®
is located,
®
is located.
®
to your
® are located.