Product Operation - Marshalltown Bullet 920 I-20-PC Manual De Instrucciones

SAFETY LOCK
For maximum security, the safety lock will automatically
reset in the "locked" position unless disengaged. The
safety lock can be disengaged by sliding the knob over
and down, hooking into slot. (Shown Right)
TRANSPORT
It is important to re-engage lock and secure unextended
handle in down position while storing, carrying, or
transporting your Magnum Edge Flooring Shear.
TIP: DOUBLE CUTTING
Most materials shear very well with just one cut.
However, some brands may require cutting twice to
produce a better cut.
Simply make your first cut 1/8" to 1/4" (3 to 6mm) longer
than your mark, then go back and make your second
cut on your mark. This is very useful to create a cleaner
cut when a trim molding or transition cannot be used to
cover your cut end.
WS2645
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

PRODUCT OPERATION

Note: Every 1" of width requires approximately 40lb (18kg) on
the handle. (e.g. a 4" wide plank requires 160lb (72kg) to cut,
5" wide plank requires 200lb (90kg) to cut.
!
USE EXTREME CAUTION! Blade is very sharp.
Making Cuts – The Magnum Flooring Shear is operated
manually. The two-part extendable handle is grasped by the
operator and pushed down to make a cut.
Cutting –
1. Unlock safety lock by sliding knob over and down.
2. Insert material. It is recommended that you HOLD
MATERIAL IN PLACE until the cut is complete
3. PUSH HANDLE DOWN TO CUT. Some effort may be
required depending on hardness of material.
4. CAUTION: Handle is spring loaded. DO NOT ALLOW
HANDLE TO SLAM BACK AFTER MAKING A CUT.
WARNING
!
7 of 18