John Bunn DigiO2 Operación Manual página 11

6. Press the Display Key for approximately
two seconds; the screen will display as
shown in Figure 9. Differences between
Figure 9 and Figure 5 are as follows:
a. In Figure 5, SpO
are being monitored and displayed
on the screen.
b. In Figure 9, SpO
perfusion index) are being
monitored and displayed on the
screen.
7. Press the Display Key twice; the screen will now display as shown in Figure 10.
8. The Display screen as shown in Figure 9 or Figure 10 will return to the original
screen as shown in Figure 5 or Figure 6 if without operation in ten seconds.
9. Alarm Indicator: When measuring, if SpO
the preset alarm limits, the device will alarm automatically and the value which
is outside the limit will flash on the screen; press the Display Key to suspend the
alarm beep (see alarm table below).
Alarm SpO
2
Pulse Rate
JB02007-INS-LAB-RevC16
and PR (pulse rate)
2
and PI (blood
2
Outside limit alarm: three beeps
Outside limit alarm: two beeps
Figure 9
value and pulse rate value are outside
2
Preset limit: ≤90%
Preset limits: Low ≤50bpm, High ≥120bpm
Figure 10
11