Safety Information - Utilitech PPTP1 Manual De Instrucciones

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the
product.
WARNING
This pump is not submersible! Do not stand in water while this pump is plugged in, and do not
get the motor wet as it could cause electrocution, which could lead to serious injury or death.
Always make sure the pump is unplugged as soon as the water level reaches 1/8 in. At
water levels less than 1/8 in., the pump is attempting to pump air, which will cause the
pump to overheat and wear out. Running the pump without sufficient water will damage the
pump and void the pump's warranty.
When the pump is running dry, it will be EXTREMELY LOUD. This is a sign to unplug the pump.
You must use the included clear suction hose on the inlet of this pump, as marked on the pump.
Always use the suction strainer included with this pump to prevent debris from damaging the
pump.
Do not pump flammable or explosive liquids such as oil, gasoline, kerosene, ethanol, etc. Do not
use in the presence of flammable or explosive vapors. Using this pump with or near flammable
liquids can cause an explosion or fire, resulting in property damage, serious personal injury and/or
death.
Always disconnect the pump from its power source before inspection.
Do not stand in water when the pump is connected. Do not handle pump with wet hands.
Do not touch the pump housing while it is operating, as the pump may be HOT and can cause
serious skin burns.
CAUTION
This pump is designed for portable applications. It can drain or remove water from the following:
flooded areas, pool covers, clogged sinks, waterbeds, water basins, boats, stock tanks, etc. It can
also be used to fill tanks or water beds. This pump has not been tested or approved for use in
swimming pools or in salt-water marine areas. This pump should not be used as a replacement for
a sump pump.
This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free
service for many years when properly installed, maintained, and used. However, inadequate
electrical power to the pump, or blockage by ice, dirt, or debris may cause the pump to fail,
potentially bringing about additional water damage. To minimize the potential for water damage
due to pump failure, please read the section of this manual regarding common pump problems
and remedies or call 1-800-346-7611.
For safety, the pump motor has an automatically resetting thermal protector that automatically will
turn off the pump if it becomes too hot. Overuse of this feature will damage the pump and void
the warranty.
Once the thermal protector detects that the pump has cooled to a safe temperature, it will allow
the pump to operate normally. You must unplug and re-plug in the pump to operate again.
3