Usage - Klarstein 10029122 Manual De Instrucciones

Buttons
BOIL:
Heat water to be boiled
Keep-warm buttons:
(70 °C, 80 °C, 90 °C)
Keep water warm to cor-
responding temperature
from boiled water, or heat
up water to the tempera-
ture and keep tempera-
ture.
Before using your kettle
If you are using the kettle for the first time, it is recommended that you should clean your kettle before use
by boiling a full kettle of water twice and then discarding the water.
NOTE: The max capacity of kettle is 1.7 l.
Using your water kettle
1. To fill water into the kettle, remove it from the power base and open the lid by pressing down the lid
button, fill with the desired amount of water to the kettle.
2. Always fill the kettle between the minimum (0.5 l) and maximum (1.7 l ) marks. Too little water will result
in the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before connecting the power cord to the outlet.
3. Close the lid. Position the kettle on the power base in place. Make sure the kettle is in contact with the
power base completely.
4. Energize. All 4 blue lamps twinkle for 5 seconds and stop, such the kettle enters standby mode.
a. Boil: Press "BOIL" button to enter boil-water function, the red lamp in "BOIL" button illumines and
start to heat the water, and when the water is boiled, the kettle stops heating and then kettle enters
standby mode.
11

Usage