Marshalltown Bullet 526-RCT26 Manual De Instrucciones página 8

The Soft Flooring EZ Shear is equipped with casters set in-line with the
blade for quick cuts along a wall. To use the caster "wall gauge":
1) Set your shear on the last full tile row and slide it so the left-right
aligned casters drop off the tile and onto the substrate.
2) Pull the shear away from the wall until the casters are touching the
last row of full tiles.
3) Place a new tile under the blade and slide it forward until it just
touches the wall.
4) Make your cut* and roll the shear to the next spot.
*Some designer tiles should be cut upside-down.
5) Drop your freshly cut tile into place.
Simply make your first cut 1/8" to 1/4" (3mm to 6mm) longer than your mark and then make a second cut on your
mark. This is very useful to create a cleaner cut on exposed ends or when you cannot over the cut edge with
molding or trim.
The anvil has two edges: a 1/32" (0.75mm) narrow edge and a 3/16" (4.5mm) wide edge. Either edge can be used
according to the support needed to make a clean cut (some soft-backed products require the wider anvil edge).
Simply remove the anvil screws and flip the anvil over. Ensure blade stop is in place.
ANVIL
8 of 14
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
USING THE WALL GUIDE
DOUBLE CUTTING
THE ANVIL
TO CHANGE BETWEEN ANVIL EDGES
TABLE
I-BEAM
TABLE
ANVIL
I-BEAM
WS2638