Safety Information - Garden Treasures C864-62 Manual Del Usuario

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install
the product.
WARNING
• Item is heavy. Two adults are required for a safe assembly.
• Keep children away from the fountain.
• Keep the power cord away from high temperatures and other sources of heat.
• Use the proper power source as indicated on the water pump label.
• This fountain pump is supplied with a grounding conductor.
To reduce the risk of electric shock, be certain that it is connected only to a properly
grounded receptacle.
• Weather conditions may cause a drop in the water levels needed to operate this fountain.
Temperature, wind, and humidity may be a factor on maintaining the proper water level.
Please check and fi ll the water level as needed and place the fountain on a level area to
prevent splashing.
CAUTION
• Assemble the fountain on a soft, non-abrasive surface, such as carpeting, to avoid damaging
the item.
• Use care when handling.
• Acceptable for indoor and outdoor use.
• Aluminum is a soft metal. Do not overtighten the connections.
• Always check water level in the bottom bowl and make sure the pump is submerged in water
when fountain is running. Water pump will be damaged without pumping water.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 20 minutes
Tools Required for Assembly (not included): Phillips Screwdriver and Adjustable Wrench
Lowes.com/gardentreasures
4
ASSEMBLY INSTRUCTIONS
1. a) Insert two screws (AA) into the holes at the end of
center post (B) and tighten.
b) Place the holes in the fl ange (C) over the screws
(AA).
c) Attach a washer (BB) and a nut (CC) to the ends of
each screws (AA) and tighten.
Hardware Used
AA
M8 x 30 Screws
BB M8 Washers
M8 Hex Nuts
CC
2. a) Turn the bowl and pump assembly (A) upside down
on a soft surface.
b) Insert three screws (AA) into the base of the bowl
and pump assembly (A) and tighten.
c) Insert the plug end of power cord through the fl ange
(C) and the center post (B), and then place the holes in
the fl ange (C) over the screws (AA).
d) Attach a washer (BB) and a nut (CC) to the ends of
each screw (AA) and tighten.
Place the safety cap nuts (DD) over each washer
(BB) and nut (CC).
Hardware Used
AA
M8 x 30 Screws
BB
M8 Washers
CC
M8 Hex Nuts
DD
M8 Safety Cap Nuts
1
CC
BB
AA
x 2
x 2
x 2
2
DD
CC
BB
AA
x 3
x 3
x 3
x 3
Lowes.com/gardentreasures
5
C
B
B
C
A