Pairing Multiple Shades To One Channel - SelectBlinds ROMAN SHADES Guia De Instalacion

PAIRING MULTIPLE SHADES TO ONE CHANNEL

NOTE: You must have at least one shade already paired to a channel, before
following the steps below.
1. Put the shade on your selected channel into "sleep" mode. To do this,
press and hold the PROGRAM button on the MOTOR HEAD until the shade
jogs and you hear a long beep. Release the button to put it to sleep.
2. Follow the steps above for "Pairing a Single Shade to a Channel" to pair a
new shade while remaining on the same channel. When you've finished, put
this shade to "sleep" as described in step 1.
3. Repeat step 2 for any additional shades you wish to add to the channel.
Once you've paired all the shades you want, "wake up" each shade's motor by
pressing and holding the PROGRAM button on the MOTOR HEAD until you
hear a short beep.
4. That's it! You can now simultaneously operate all the shades paired with
this channel.
ADJUSTING THE UPPER/LOWER LIMITS
Your shade's upper and lower limits are already pre-set at the factory, so the
following steps are only necessary if you want to change how these settings are
configured. The upper limit can ONLY be changed after performing a factory reset
(see page 4).
CHANGING THE UPPER LIMIT
NOTE: Prior to resetting the upper limit, you must first follow the instructions for
performing a factory reset. This is the only way to change the upper limit.
1. Move the shade using the UP or DOWN buttons, until it is positioned about 6"
below the desired upper limit.
2. Press the PROGRAM button on the back of the remote. The shade will jog,
indicating it's now in programming mode.
3. Press the UP button to move the shade to the desired upper limit. Press the
PROGRAM button on the back of the remote again and the shade will jog.
4. That's it! You've now reset your shade's upper limit, and the motor will exit
programming mode automatically.
CHANGING THE LOWER LIMIT
1. Move the shade using the UP or DOWN buttons, until it is positioned about 6"
above the desired lower limit.
2. Press the PROGRAM button on the back of the remote. The shade will jog,
indicating it's now in programming mode.
3. Press the DOWN button to move the shade to the desired lower limit. Press
PROGRAM on the back of the remote again and the shade will jog.
4. That's it! The lower limit is set, and the motor will exit programming mode
automatically.
®
Simple. Smart. Custom.
INSTALLATION GUIDE | ROMAN SHADES
1 2 3 4 5 6
SHADE #1 SHADE #2
PROGRAM
BUTTON
1 2 3 4 5 6
1 2 3 4 5 6
UPDATED SEPTEMBER 2020 3