oneConcept 10030580 Manual De Instrucciones página 12

EN
12
OPERATION
Note: if your cooler is DC version only, please never try to connect to the
AC network directly! It should be fits into AC/DC adaptor (13) which makes
it possible to use the cooler via the AC supply at home, in hotel or office.
Operation States
Your cooler can either cooler or heat, the change from cooling to heating takes
place by a sliding switch (10). The working state are indicated by integrated
leds, green (11) for cooling, and red (12) for heating.
Your cooler (AC/DC version) can be
used on either AC power source or
DC power source and equipped with
AC power cord & DC power cord.
• When the power supply is AC,
put the power switch on „off"
(1 ). Connect one end of the AC
power cord (2) to the AC input
(3 ) of the cooler, and put the
AC plug to the AC socket, make
sure the switch is on the proper
position „AC" (4).
• When the power supply is DC,
put the power switch on „off"
(1 ). Connect one end of the DC
power cord (5) to DC input (6) of
the cooler, and put the cigaret-
te plug (7) to cigarette lighter
socket (8) of the car or yacht,
make sure the switch in on the
proper position „ DC" (9).