Publicidad
Idiomas disponibles
Idiomas disponibles
7. Carry (DO NOT DRAG) your O-Zone product to the water. Flip
bouncer upside down in shallow water.
Tie a knot in one end of lacing rope.
Align large grommet holes of apron over
the three rope holders on the underside
of the boarding platform. Starting at the
outermost rope holder on the bottom of
the bouncer, lace alternately between
bouncer and boarding platform. Loosely
tie other end of rope.
Flip entire unit face up in the water. Pull
rope until the platform is snug against side of bouncer and there
is no gap.
Check to make sure rope is spread
evenly between rope holders. Tie off
rope to keep the boarding platform snug
to the bouncer.
Periodically check to ensure the
protective apron is laying flat over the
ropes and the ropes are not exposed
between the boarding platform and the bouncer.
Inflating and connecting the slide
1. Inflate the main body chamber of the slide. DO NOT OVER
INFLATE. Inflate until firm and the slide stands upright.
2. Inflate both side rails on top of slide until firm. DO NOT OVER
INFLATE as the heat of the sun will cause the air to expand.
Release air throughout day if necessary.
Note: Moisten the plug of the clear stem valve prior to inserting it
into the valve and push plug into the valve body fully.
4
Publicidad
