Uline H-3702 Manual Del Usuario página 10

NOTE: Changing the scale parameters to values other than the recommended values may result in poor
scale operation.
NAME/CODE
F1: GRADUATIONS
F2: SPAN GAIN
F3: ZERO TRACK BAND
F4: ZERO RANGE
F5: MOTION BAND
F6: DIGITAL FILTER
F7: OVERLOAD LIMIT
F8: CALIBRATION UNIT
F9: DISPLAY DIVISIONS
F10: DECIMAL POINT
F16: ZERO CALIBRATION
F17: SPAN CALIBRATION
PAGE 10 OF 34
RECOMMENDED SCALE CONFIGURATION VALUES
Specifies the number of full-scale graduations. Value should be
consistent with legal requirements and environmental limits on the
useful system resolution.
Span Gain is related to A/D integration time. The larger the span
gain, the higher the internal resolution, but the slower the update
speed. Note that the scale must be re-calibrated whenever this
parameter is altered. See Appendix C in the scales manual for
more information.
Selects the range within which the scale will automatically zero.
Note that the scale must be in a standstill to zero the scale.
Selects the range within which the scale may be zeroed. Note that
the indicator must be in standstill to zero the scale.
Sets the level at which motion is detected by comparing the
present display update with the previous one. If motion is not
detected for two seconds or more, scale is in standstill and
can process a Print or Zero command. Maximum value varies
depending on local regulations.
Averages weight readings to produce higher stability but slower the
indicator's response time. Choose 8 unless a very fast response is
needed.
Selects the desired formula which determines the point at which
the indicator shows overload. All selections are based on the
primary unit selected in F8.
Selects the primary base unit to be used in the calibration process.
Also the default unit for normal operation. 1 = pounds, 2 = kilograms.
Determines the desired weight increments. Value should be
consistent with legal requirements.
Determines the location of the decimal point.
Places the scale in a Zero Calibration routine.
Places the scale in a Span Calibration routine.
DESCRIPTION
RECOMMENDED
VALUE
5000
100
3
100
1
8
2%
1
1
0
—
—
0321 IH-3702