Hamilton Beach 67735 Manual Del Usuario página 10

Troubleshooting
Machine will not work when switched ON.
• The Locking Latches may not be correctly engaged. Check to see if the Locking Latches are properly positioned in the two grooves on
either side of the Juicer Cover. Refer to page 5, Steps 3 and 4.
• This machine is equipped with motor overload protection. If the motor stops during operation due to overheating, unplug and allow it to
cool down for 15 minutes. Plug machine back in after 15 minutes to resume normal operation.
Motor appears to stall when juicing.
• The juicing action may be too vigorous. Try slower juicing action by pushing the Food Pusher down more slowly. Refer to page 6,
Step 3.
• Wet pulp can build up under the Juicer Cover or Pulp Container. Turn unit OFF ( ) and unplug. Empty the Pulp Container; then clean
Juicer Cover and Strainer Basket.
Excess pulp building up in the Micro-Mesh Strainer Basket.
• Turn OFF ( ) and unplug. Remove Strainer Basket and clean mesh walls with a fine brush. This will remove excess fiber buildup which
could be inhibiting the juice flow. Refer to pages 7 and 8.
Pulp is too wet and insufficient juice is produced.
• Try a slower juicing action.
• Turn OFF ( ) and unplug. Remove Strainer Basket and clean mesh walls with a fine brush. This will remove excess fiber buildup which
could be inhibiting the juice flow. Refer to pages 7 and 8.
Juice sprays out of Spout.
• Try a slower juicing action by pushing the Food Pusher down more slowly. Refer to page 6, Step 3.
Juice drips out of Spout immediately after juicing.
• With motor ON, raise and lower Food Pusher in Feed Chute several times. The action forces remaining pulp and juice out of Strainer
Bowl.
Machine vibrates excessively.
• Buildup of pulp in mesh of Strainer Basket. Turn unit OFF ( ) and unplug. Clean Strainer Basket. Refer to page 8. If machine vibration
continues after cleaning, this could be a sign of a damaged Strainer Basket. Call our customer service number to order a new Strainer
Basket.
10