Tools Required - Whittier Wood Products Bistro 174W Instrucciones Para Armar

174W Bistro Counterstool & 175W Bistro Barstool
Phillips Head Screwdriver, Wood Glue, Rubber Mallet or Padded Hammer.
E
D
FIG. 1
1) Lay out the Back-Top (A), Back-Bottom (C), and Back Stretcher (D) in their approximate positions
between the Left Back Leg (E) and the Right Back Leg (F). Note that the longer back piece is near
the top of the back leg and the shorter piece is near the bottom. See FIGURE 1.
Spread glue evenly in the two slotted holes and the one round hole in the side of each Back Leg
(E & F). Starting at the top of one back leg, insert the Back-Top (A), Back-Bottom (C), and Back
Stretcher (D). Now insert the back pieces in the other back leg. It is important that all the back
pieces (A & C) are firmly and completely seated in both back legs and their shoulders must be
against the back leg.
2) To hold the back leg assembly together while the glue dries, use a piece of rope approximately
five feet long. Wrap the rope loosely around the back assembly near the center of the back legs
(protect the back legs with cardboard or cloth) and tie the ends in a square knot. Loop the rope
around a dowel or screwdriver and twist until tight. Tie down as shown in FIGURE 2. Leave rope
in place at least one hour.
Insert a #8 x 1¼" Pan Head Screw (O) through the hole in the outside edge of each back leg into
the Back-Top and fasten securely. See FIGURE 2.
PAGE 4 — 174W/175W
ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED:

C
F
SHOULDER
A
O
FIG. 2
IMPORTANT:
READ GLUING HINTS
BEFORE ASSEMBLING!
Not intended for use by
children without adult
supervision.
O