A
4
4
D
10
17. Fasten 2 Cable Wheels (L) to the Lower Back Panel (D) with four Small Bolts (10). The cable wheels
allow you to organize, route and separate your component cords and cables to minimize tangling and
signal interference.
18. Using the pilot holes as a guide, fasten the Cord Clip (11) to the backside of Desk Top (A) with three 15
mm Screws (4).
19. Feed the wire of Power Center (M) through the cutout of the Upper Back Panel (C) and push into the
cutout. Secure it in place with the two 15 mm Screws (4). Make sure the wire is not pinched.
Assembly Instructions
11
4
L
A
D
12
M
C
4
4
C