Verde 96848 Manual De Instrucciones página 19

Cod 96848
– Allow the fuel to run out completely.
– Screw the tank cap on firmly by hand.
Start on the unit
Do not start the unit until it has been completely assembled. Before switching on the unit, always
checking the oil
Check before use!
Danger of injury!
Do not operate the device unless you did not find any faults. If a part has
became defective, make sure to replace it before you use the device again.
DANGER!
Check the safe condition of the device:
– Check the device for leaks.
– Check the device for visual defects.
– Check that all parts of the device have been securely fitted.
– Check that all safety devices are in proper condition.
Danger of injury!
Before starting work, always check the ground and remove all objects
which could be thrown by the device.
DANGER!
Once the machine has been set up properly, start the engine as follow:
1. Attention: When the brush cutter is used and started for the very first time, the final user is
warmly recommended to push the primer pump for 4/5 times at least, so has to obtain the
best performance of the equipment for future use as well.
2. Turn the engine switch to the ON position.
3. Put the choke lever on the A (OFF)
4. Pull the recoil starter handle 3-5times to start the engine.
It needs to be hold the throttle trigger when starting.
5. Adjust the choke lever to B (half open)
position
position.
30