Emptying The Filter - Aqua EZ RVP31 Manual De Usuario

1) Bring your pool vacuum to the side of your pool / spa. Immerse the pool vacuum in
water and press the power button to initiate operation.
CAUTION! Make sure the pool vacuum is always facing downwards when it is placed
into the pool. Otherwise it may bend the pole connector and damage it during the
process.
2) To remove the pool vacuum from the pool / spa, lift the pool vacuum while pointing
it downwards in order to allow water to escape from the outlet valve. Water is going to
escape via the handle / pole connector and draining holes inside the handle chamber
on the rear body.
CAUTION! Make sure the pool vacuum is always facing downwards when it is
removed from the pool. Otherwise, the pole connector may be bent and damage the
pool vacuum in the process.
3) Rinse the pool vacuum with fresh water after every use. DO NOT use any
detergent.

EMPTYING THE FILTER

WARNING!
Using the pool vacuum without a filter cage in place will VOID
your warranty.
In order to maximize the cleaning efficiency, be sure to clean the filter cage before
and after each use.
CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the
power source and detach the pool vacuum from the charger base.
 Emptying the filter cage
1. Place the pool vacuum on a stable surface.
2. Press the locking button until the locking hole on the clear canister is released.
Slide the canister away until the notch on the bottom of canister opening is released
from the hook on the bottom of main body. Remove the filter cage from the main
body.
CAUTION! Replace the damaged filter cage immediately before the next operation.
3. Clean out the debris and rinse the filter cage with water. If brushing is deemed
necessary, use only a soft brush to clean the cage gently and carefully.
4. Re-position the filter cage inside the main body. Make sure the filter cage is
completely inserted inside the main body.
8