KTC FS40-12P Instrucciones página 8

ASSEMBLY OF CROSS STAND & COLUMN UNIT
1. Loose 4 sets of screws, washers and spring washers which are beforehand
fitted in the center section on the stand and assembly the extension pole onto
the base enclosure with these screws. (Fig.1)
2. Loose the height adjustment ring, lift the internal pole to the max height and
prevent the internal pole from slipping into the extension pole, then screw out
the height adjustment ring. (Fig.2)
3. To attach the decoration cover (cover for the stand), slide the decoration cover
down the extension pole. (See Fig.3)
4. Reattach the height adjustment ring. (Fig.4)
5. From the extension pole loosen the height adjustment ring and adjust the
internal pole to the desired height. (Note: If you can't find the internal pole, it
slides inside the extension pole. You can pull it out from the extension pole.)
(Fig.5)
6. To attach the head unit to the extension pole, loosen the thumb screw on the
bottom of the head unit. Place the head unit on the extension pole and tighten
the thumb screw in alignment with the groove on the internal pole. (Fig.6)
8