GRAPHITE 59G446 Instrucciones De Uso Originales página 12

TRANSLATION OF THE ORIGINAL INSTRUCTIONS
CAUTION: BEFORE USING THE TOOL READ THIS MANUAL CAREFULLY AND KEEP IT FOR FUTURE REFERENCE.
SAFETY OF USER OF SUBMERSIBLE PUMP FOR DIRTY WATER
Connection to mains network should be done by a licensed electrician and accordingly to IEC 364. Use
of residual current device is required, which breaks the circuit when earth leakage current exceeds 30mA
for 30 ms.
Do not direct the pump water stream onto people, electric equipment and the device itself.
Disconnect the pump from power supply when performing maintenance tasks.
Children are not allowed to operate the pump.
Do not pull or hold the pump by its power cable or water hose. Use corrosion resistant cord attached
directly to the pump handle for this purpose.
To ensure safe operation use only spare parts that are approved by the manufacturer or original.
Use connectors and equipment supplied by the manufacturer.
Do not use the pump in case of damage of power cable or any other part of the device, e.g. residual current device,
water hose etc.
When extension cord is used, socket and plug should use earthing prong (connection).
The pump is designed for household use.
The pump can be used indoors and outdoors.
Water float must rest freely on water surface, it should not have contact with obstacles. Blocked
movement may cause pump damage.
The pump is designed so all moving parts and the casing allow for safe operation. The manufacturer
is not responsible for losses resulting from modifications of the device.
Do not use the pump for liquids other than water, especially engine fuels, cleaning liquids and other
chemical products.
CAUTION!
The design is assumed to be safe, protection measures and additional safety systems are used, ne-
vertheless there is always a small risk of operational injuries.
CONSTRUCTION AND USE
Submersible water pump is a I protection class device designed for pumping out clean water or dirty water
containing particles with maximum diameter of 20 mm. The pump is designed to operate under water.
When installed in appropriate well, it may be protection against flooding. It is ideal for removing water from
garages, basements, tanks or excavations flooded with rain water. The pump is designed to pump water at
maximum temperature 35
Special base is specific feature of the pump, it allows to pump out the water down to 5 cm level. The pump features
automated float switch, which allows the pump to switch on and off by itself. It protects against dry operation. Built-in
vent valve allows easy water suction.
Use the pump according to the manufacturer's instructions only.
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the drawing pages of this manual.
1. Handle
2. Float switch
3. Inlet holes
4. Connection
5. Connector pipe
6. Blanking plug
* Differences may appear between the product and drawing.
SUBMERSIBLE PUMP FOR DIRTY WATER
59G446
DETAILED SAFETY REGULATIONS
0
C.
12