Fcc Notice - Fellowes Optical Serie Guía De Instrucciones

Optical Series 042704 4/27/04
B. Conexión al puerto USB o PS/2:
USB: (se requiere Windows 98SE o
superior) conecte el cable al puerto
USB de la computadora (o a un puerto
USB del concentrador conectado a su
computadora). Para la instalación en el
puerto USB no es necesario apagar
el equipo.
PS/2 (para los modelos que
corresponda): el puerto PS/2 no es el
método de conexión recomendado; el
puerto USB ofrece mayor funcionalidad y
control en comparación con el PS/2.
a. Apague el equipo.
b. Instale el conector de PS/2 a la toma de USB e inserte el conector de
6 clavijas al puerto PS/2.
C. Encienda el equipo.
C. Colocación de las pilas (modelos inalámbricos únicamente):
NOTA: Cargue las pilas en forma completa antes de usarlas por primera vez.
Cada vez que coloque pilas nuevas, asegúrese de que ambas sean pilas nuevas
de NiMH recargables AA o AAA (según el modelo).
1. Retire la tapa del compartimiento de pilas que está en la parte inferior
del mouse.
2. Inserte las dos pilas AAA (o AA) de NiMH recargables en el compartimiento
de pilas. Asegúrese de que los extremos positivo (+) y negativo (-) estén
bien orientados, tal como se indica en el compartimiento de pilas. Pueden
instalarse pilas alcalinas; no obstante, Fellowes no recomienda recargar pilas
alcalinas. La función de recarga de pilas se recomienda únicamente para las
5-C
1.42 PM Page 5
expressly permitted above). User may not transfer the software or
Fellowes input product except upon permanent transfer, provided user
does not retain a copy of the software, and provided transferee agrees
to be bound by the terms and conditions of this license. Upon any
violation of any of the provisions in this agreement, rights to use the
software shall terminate and all copies shall be returned to Fellowes.
9
FEDERAL COMMUNICATIONS
COMMISSION (FCC) NOTICE:
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in particular installations, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
1. Reorient / Relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that
the receiver is connected.
4. Consult the dealer or an experienced radio / TV technician for help.
CAUTION: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.
13-A