Kohler K-T9493 Instrucciones De Instalación página 9

COMPLETE TRIM INSTALLATION - ALL
MODELS
Press the mixing valve knob onto the mixing valve stem
so the knob button and "104" mark face upward (toward
the escutcheon detent), as shown. Verify that the knob
does not rotate counterclockwise. Do not press the knob
button.
Turn on the water for a few minutes to allow the
temperature to moderate. Then use a thermometer to
check the water temperature. The water temperature
should be 104_ F (40_ C).
NOTE: Units sold internationally will have Celsius
temperatures listed on the mixing valve.
If the water temperature is 104_ F (40_ C), press the knob
button and rotate the knob fully counterclockwise so the
"120" mark faces upward. Check the water temperature
again. It should now be 120_ F (49_ C). Turn the knob
clockwise so the "104" mark is upward. Again check the
water temperature to make sure it is still 104_ F (40_ C).
Turn off the water.
If the water temperature does not match the temperature
indicated on the knob, repeat the mixing valve calibration
steps according to the "Adjust Temperature Settings"
section starting on Page 6.
Secure the mixing valve knob to the valve stem with the
screw. Install the thin O-ring into the first groove in the
knob. Carefully position the uninstalled grip ring into the
second groove in the knob.
Press the cap onto the valve so the cap detent is in line
with the knob button. If needed, apply a small amount of
the supplied silicone lubricant (capsule included in
hardware kit) to the inside wall of the cap to aid in
assembly.
Kohler Co., Kohler, WI U.S.A.
Detent
Farenheit
Detent
Detent
O-Ring
Silicone Lubricant
(if needed)
9
Mixing Valve
Stem
Mixing
Valve Knob
Celcius
Screw
Grip Ring
Fig. #10
1012606-2-
Detent
Cap
A