How To Assemble Your Light Kit Assembly - Fanimation AIRE DELUXE FP6245B Serie Manual Del Usuario

How to Assemble Your Ceiling Fan Blades (Continued)
3. Secure the blade holders to the bottom of the motor
assembly using the 1/4"-20 screws from the hardware
bag. (Figure 3)
NOTE: Periodically check blade holder hardware and
resecure if necessary.
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.

How to Assemble Your Light Kit Assembly

1. Remove the four screws in light kit assembly.
Retain the screws for step 4. (Figure 1)
2. Remove one of the three screws in the support
bracket. Slightly loosen the remaining two screws.
Assemble the adapter-switch housing to the housing
support bracket using the two key slots in the adapter
switch housing. Replace the third screw and securely
tighten all three screws. (Figure 2)
3. Securely attach the 9-pin connector from the motor
assembly to the wire harness socket within the light kit
assembly. (Figure 3)
WARNING
The color label on these two connectors must
correspond to each other.
Blade Holder
1/4"-20
Screws
Light Kit
Assembly
Adapter Switch Housing
13
1/4"-20 Screws
(2 per assembly)
Figure 3
HARDWARE USED:
X 10
Figure 1
Figure 2
Motor Assembly
Light Kit Assembly
Figure 3