Microsonic TEL2911 Guia De Inicio Rapido página 10

REDIAL/P to dial the number out again.
PAUSE
When dialing, press REDIAL/P key to insert a 3.6s pause time between dialed numbers.
P-T SWITCH
Slide the mode switch on the side of the telephone to T (TONE) or P (PULSE) to select dialing mode.
PULSE AND TONE DIALING SWITCHABLE
When it is at pulse dialing mode, you can press * key to change pulse to tone dialing mode.
For example, when it is pulse dialing mode, at off-hook state, you press "123 *45678", the unit will dial 123 at
pulse dialing mode, while dial 45678 at tone dialing mode.
ADJUSTING RINGING VOLUME
Slide the RING switch to HI (high) or LO (low) to select desired ringer volume.
TROUBLE SHOOTING
No dial tone
Check hook switch to make sure it pops up.
Noise
Check if the circuit is broken, change the circuit.
Check if the connector is moist or rust, change the connector.
Ring once then disconnect when receive a call. Dialing function is available
Check if connector is in a moist environment.
Check if too many extensions are used together or the quality of extension is not good enough, change
the bad extension.
Note: Due to continuous product development, all features and specifications are subject to change without
prior notice.
10