Descargar Imprimir esta página

Better Homes and Gardens BH1609209920 Manual Del Usuario página 2

Silla

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION: FAILURE TO PLACE METAL PLATES ON THE CORRECT POSITION AS SHOWN IN THE DIAGRAM WILL CAUSE THE BOLT HEAD AND NUT TO DAMAGE
THE STRUCTURE OF THE ROCKER PLATE AND THE CHAIR FRAME.
Step 4: Tighten all nuts and bolts with the hex wrenches provided. Do not over-tighten. Remove red arrow labels from the chair frame and chair base. Cover all bolts & nuts
with the PVC bolt covers (G) provided.
Step 5: Double check your assembly procedure, especially Step 3 if your chair is not rocking properly. If the chair rocks too far forward or is difficult to rock backwards, you
have probably installed the seat frame backwards on the chair base. Please call our CUSTOMER SERVICE CENTER if you need further assistance.
Step 1: Identify all parts packed in the carton
against the part list. Remove all protective
materials and place on a non-abrasive surface to
avoid scratching.
Step 2: It is recommended that 2 people work
together to assemble the chair. Set the chair
frame (A) on the chair base (B). Both the red
arrows on the frame and base need to be
pointing in the same direction as shown in the
diagram.
Step 3: Read this step carefully and examine the
diagram. The four metal plates (D) must be
installed in the proper location. Aligning the holes
in the metal plate with the plate in the chair
frame, guide the bolts (C) through the holes from
metal plate to the chair frame, chair base and
most importantly, through another metal plate
which must be placed directly beneath the rocker
plate. Add a washer (E) and a nut (F) to each bolt.
Hand tighten nuts 3 to 4 revolutions only. Repeat
the same procedure on the other side.
IF YOU HAVE QUESTIONS OR CONCERNS, PLEASE CALL BOND TOLL FREE # 1-866-711-BOND (2663)
OR TO BETTER EXPEDITE YOUR REQUEST FEEL FREE TO EMAIL US
OR VISIT OUR WEBSITE UNDER CUSTOMER SERVICE SUPPORT
NOTE: MAKE SURE RED ARROWS ON THE CHAIR FRAME (A)
& CHAIR BASE (B) ARE POINTING IN THE SAME DIRECTION.
customer.service@bondmfg.com
www.bondmfg.com
BOND MANUFACTURING CO.
1700 West 4
th
Street, Antioch, CA 94509
Page 2

Publicidad

loading