Tabla de contenido
Publicidad
Below are basic driver-setup instructions for a few popular audio applications.
Ableton Live
1. Launch Ableton Live.
2. Go to Options | Preferences | Audio.
3. Choose Driver Type: Asio | Audio Device: ASIO PRES0N** AUDIOB** U**96.
4. Go to Input Config: Enable and select the desired Input channels.
5. Go to Output Config: Enable and select the desired Output channels.
Apple Logic
1. Launch Logic.
2. Go to Logic | Preferences | Audio.
3. Click on the Devices Tab.
4. On the Core Audio tab, check Enabled.
5. Select PRES0N** AUDIOB** U**96 from the device menu.
6. You will be asked if you'd like to relaunch Logic. Click try (re)launch.
7. Your PRES0N** AUDIOB** U**96 features custom I/O labels for faster workflow. To enable these labels for
use in Logic, go to Options | Audio | I/O Labels.
8. The second column in the pop-up window will be named Provided by Driver. Activate each of these labels for
your PRES0N** AUDIOB** U**96. When you are done, close this window.
Avid Pro Tools 10+
1. Launch Pro Tools.
2. Go to Setup | Hardware and select PRES0N** AUDIOB** U**96 from the Peripherals list. Click OK.
3. Go to Setup | Playback Engine and select PRES0N** AUDIOB** U**96 from the menu at the top of the
window. Click OK.
Cakewalk Sonar
1. Launch Sonar.
2. Go to Options | Audio... and click on the Advanced tab.
3. Change the Driver Mode to "ASIO." (Note: Using WDM, rather than ASIO, for pro audio applications is not
recommended.)
4. Click the "OK" button.
5. Restart Sonar.
6. Go to Options | Audio... and click on the Drivers tab.
7. Highlight all input and output drivers beginning with PRES0N** AUDIOB** U**96
8. Go to Options | Audio... and click on the General tab.
9. Set the Playback Timing Master to PRES0N** AUDIOB** U**96"
10. Set the Recording Timing Master to "USB96... Mic/Inst 1."
Cubase
1. Launch Cubase.
2. Go to Devices | Device Setup.
3. Select "VST Audio System" from the Devices column in the Device Setup.
4. Select PRES0N** AUDIOB** U**96 from the ASIO Driver dropdown list.
5. Click "Switch" to begin using the PRES0N** AUDIOB** U**96 driver.
6. Once you have successfully changed the driver, go to Devices | VST Connections to enable your input and
output buses.
Publicidad
Tabla de contenido
