Publicidad
Idiomas disponibles
Idiomas disponibles
Secure Ironing Board Inside Cabinet
For Recessed Mounting Only, secure the IRONING BOARD
ASSEMBLY to the sides of the cabinet using four ROUND
HEAD SCREWS (two on each side) and two WALL SCREWS
(2" long) one each in the back, center hole of each side
bracket. These screws go through the cabinet sides and into
the wall studs. You may have to unlock the IRONING BOARD
ASSEMBLY and adjust the position to get access to the screw
locations.
For Surface Mounting Only, secure the IRONING
BOARD ASSEMBLY to the sides of the cabinet with six
ROUND HEAD SCREWS. Level cabinet. Drive two WALL
SCREWS into the two holes in the back bracket of the
Ironing Board Assembly that correspond to the hole used
at the top of the cabinet by the previous screw, securing
the ironing board assembly directly to the wall stud.
Install Ironing board Cover
Stretch COVER around the extended ironing board surface. Pull and tie the drawstring,
then hook the loops in the center of the cover to the hooks on the hinges.
Install Trim (Recessed Mount Only)
A roll of peel-and-stick trim is supplied to hide the rough edges of the wall opening on
the sides and top of the cabinet. Cut the desired pieces to length and fold 90 degrees
with the adhesive towards the outside of the fold. Peel adhesive and apply to where
the cabinet meets the wall.
To Operate the Ironing Board
2" Wall
Screws
go here
Pulling down on the
HANDLE releases
the board, allowing
it to fold up or down.
For Ironing Center Mounted Low On Wall
For Ironing Center Mounted on Mid-Wall
Tightening the plastic
KNOB keeps board from
swinging or tipping
forward while ironing.
Extend the ironing
Pull up the
board. Swing to the
ironing board
desired location and
until it locks.
tighten KNOB.
Pull HANDLE
Extend the ironing board.
and pull down the
Swing to the desired
ironing board
location and tighten
until it locks
KNOB.
Done?
Fold The Board, then pull
the HANDLE and retract
the unit back into the
cabinet.
Done?
Fold The Board, then pull
the HANDLE and retract
the unit back into the
cabinet.
Publicidad
