Hamilton Beach HHD601 Manual De Uso página 6

Operation Instructions
TESTING THE ALCI PROTECTION DEVICE
This appliance is equipped with a
polarized Appliance Leakage Circuit
Interrupter plug (ALCI). This device
will automatically shut off hair dryer
under certain abnormal operating
conditions, such as submersion of
dryer in water.
The ALCI must be tested before
each use of the hair dryer.
1.
Make sure ALCI is plugged in; then press the "Reset" button.
2.
Press "Test" button. The "Reset" button should pop out, which
indicates the ALCI is working properly.
NOTE: If the "Reset" button does not pop out during the test, or
pops out before or during operation, or if hair dryer fails to function
properly, do not operate hair dryer. Refer to the warranty.
3.
Press the "Reset" button again to reactivate the ALCI. You are now
ready to operate the hair dryer.
4.
If Auto Monitoring Light stays on or continues to blink, or
Reset Button continues to pop out, the ALCI is not functioning
properly. Stop using Hair Dryer and email customer service for
information on examination and repair.
5.
In addition to the above required manual test, your ALCI plug
will automatically conduct a test every few minutes. If the Auto
Monitoring Light stays on or continuously blinks or the Reset
Button pops out, unplug and allow the appliance to cool. Press
Reset Button and plug into outlet. The appliance should then
function normally. If not, email customer service for further
instructions.
ALCI
Plug
6