Initial Use; Dimming The Mood Light; Setting Rgb Colours; Charging Your Smartphone's Rechargeable Battery - LIVARNO LUX TY1200100E1mn Instrucciones De Utilización Y De Seguridad

Safety / Initial use
operating voltage of the mains adapter (see
„Technical Data").
Never allow the cables to touch or allow the
product to come into contact with water or
other liquids.
Never open any of the components of the
electrical equipment or insert any objects into
the components. This will pose the risk of fatal
injury from electric shock.
Always unplug the mains adapter from the
socket before cleaning.
Do not touch the mains adapter with wet hands.
To prevent hazards, a damaged connection
cable must be replaced by the manufacturer or
a professional.
For your safety
Position the mobile phone charging station in a
place where it is protected from moisture and
dirt.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Do not cover the mobile phone charging station
with objects. Excessive heat build-up can result
in fire.
Do not look into the LED from a close distance
during operation.
Do not look at the LED with an optical instrument
(e.g. magnifier).
Plug the mains adapter into an easy to access
socket.

Initial use

Note: Remove all packaging material from the
product.
Insert the coaxial power connector of the mains
adapter into the connection socket
7
the underside of the mobile phone charging
station (Fig. B).
Insert the mains adapter into the mains socket
(Fig. C). The charging status indicator will
briefly flash.
14 GB/IE
Press the
light.

Dimming the mood light

Press the
light mode.
Slide your finger over the touch slider
regulate the brightness (direction + = brighter,
direction - = darker) (Fig. D I).

Setting RGB colours

Press and hold the
3 seconds to reach RGB colour mode.
Slide your finger over the touch slider
select the colours (Fig. D I).
Charging your smartphone's
rechargeable battery
Place your QI compatible smartphone in the
charging area
station (Fig. D IV).
The charging status indicator
red during the charging process. When the re-
chargeable battery has been fully charged the
charging status indicator will turn green.
If your smartphone is not QI compatible,
proceed as follows:
Insert the micro-USB plug of the charging
receiver
smartphone (Fig. D II). Place your smartphone
with the ribbon cable connected in the charging
area
2
For iPhone mobile phones, please use the other
charging receiver.
on
6

Using the mobile phone case

Connect the mobile phone properly with the
respective charging pad provided.
button to switch on the white
4
button to reach warm white
4
button
4
of the mobile phone charging
2
1
into the micro-USB socket of your
8
of the mobile phone charging station.
to
3
for approx.
to
3
will light up